Showing all 38 results

Show sidebar


CMC 1/12th Gauge Tufting

Quantity: 1, Year: 1998, 5 meter, 1/8th level loop front and ¼th scroll rear. 24” cam shifter. Servo backing feed. Servo on front yarn feed with 5” rollers. 96 clutches. Sewing 144”. Machine only with no creel, beam racks, mending frame or rollup. loaded in one 40HC and one 20 ft container.
This machine was making carpet tiles. The front side tufts a 1/8th gauge level loop and the rear (1/4th gauge) has the scroll attachment to make patterns. Patterns making in this machine is limited.
Loopers and needle plates are installed if buyer wants to Tuft 4 meters. Buyer should add needles only.


CMC 1/8th Gauge Tufting

Quantity: 1, Year: 1982, Gauge 1/8, 4 meter.
Cut Pile Graphics tufting machine currently tufting 130 inches.
Staggered needle bar. Blade blocks out to 150 inches.
Dual 4” yarn feed. Two 16” cam shifters. Inverter panel.
NOTE: Machine Tufting Width in factory was 330 cm, it will be changed to 4.1 Meter (410 cm), requires parts will be added for 4.1m Tufting. (THE MAXIMUM POSSIBLE WIDTH IS 162 INCHES OR 411CM.)
Machine is in production condition but now dismantled and moved to warehouse.
Requires 1x 40HC container for shipment.
This is for the machine only and does not include creel, mending frame or rollup.


CMC 1/10″ Cut Pile

Quantity: 1, Year: 1988 , Width: 4000 mm, Creel: NO creel – with beams , Gauge: 1/10 ” , 1440 needles on 3660 mm – sliding needle bar.


CMC Loop Pile Tufting Machine

Quantity: 1, Year: 2008, Concept 2000 From 2008,5 meters wide,1/10 gauge with single sliding needle bar with cam.
Very low working hours


CMC 1/10th Gauge ELG (Enhanced Loop Graphics) Tufting

Quantity: 1, Year: 1998, 5 meter. 6 roll, servo driven rainbow each side.
Estimated Production: 750 RPMs, 12 St/in, 4 meters wide, 70% efficiency, 67 Lin Mtr per hr, 286 sq mtrs per hr.
Loaded in two 40HC containers.


CMC Tufting

Highest quality machine from high ranking Tufting Factory.
Quantity: 1, Year: 2005, LCL type, 1/8 gauge, 4.1m Width, Machine is 410 cm Tufting width, but it was Tufting 366 cm width. Minimum pile height of 3/8 inches (6mm) and max pile height 9/16 inches (14 mm), Speed 800 rpm. Needle bar in line, feeded by servos with mending frame, carpet inspection and roll up. No Creel, It has 4 servos. 2 for polyback in & out process, 1 for the roller feed and 1 for the groove roller feed . It also has an Smart step for zigzag system, Front Shifting Module, Chain Drive, Denier 1400, 2 Ply, Speed: 800, Stitches per inch 8-12, Pile Height min-max: 3/8, 9/16 inch.